Service ManualMTD Products LLC - Product Training and Education DepartmentFORM NUMBER 769-014169/200431AS2B5 Snow ThrowerIMAGE SHOWS YARD-MAN UNITNOTE
611. FRONT SHROUD COVER REMOVAL 11.1. Remove the three screws from the inside top of the auger housing using a 3/8" socket and ratchet. See Figur
7bling easier to leave the lower chute attached and remove the deflector. See Figure 23. 11.6. Remove the gas cap and the oil dipstick and then lift o
8NOTE: During reassembly, align the chute assembly by facing it towards the plastic retain-ing ring. Be sure the chute is positioned all the way to th
913. GAS TANK13.1. A wire retainer holds the gas tank. The tank can easily be replaced by pushing the wire out of the lower support plate at the bend
TABLE OF CONTENTSGeneral Information ... 1Controls ...
131AS2B5-711Snow Thrower Model Number #31AS2B5- 711 Serial Number 1E074B20005 NOTE: The equipment that was used to write this section was a prototype
2switch and the A.C. plug connector with starter button that is used for the electric start. See Figure 3. 4. BACK OF UNITThe Model tag is located on
37. DISCHARGE CHUTEThe mitten grip handle on the snow chute allows easy adjustment side to side. See Figure 7. 8. AUGER DRIVE BELT REPLACEMENT 8.1. R
4engine pulley. Replace by using the same proce-dure. See Figure 11. 9. AUGER REMOVAL 9.1. Place a two by four wedge in the housing to hold the auger
59.4. Remove and inspect the bearing and heavy washer for ear or damage. See Figure 15. 9.5. Facing the housing, slide the auger assembly to the right
Comments to this Manuals