Mtd 243-630-000 User Manual

$1.00OWICirS GUIDE• ASSEMBLY • OPERATION • MAINTENANCE • PARTS •LOGSPLITTERModel Number 243-630-000Important:Read Safety Rules and Instructions Carefu

SplittingWedgeResei voir TalkEnd Plate FIGURE 13.—Vertical PositionControlFIGURE 14.—Horizontal PositionTO OPERATE LOG SPLITTER:1. Set throttle at ma

Hex BoltsMAINTENANCEAdjustment BoltsBack.PlateFIGURE 15.Periodically remove and replace the “gibs” (spacers) between the wedge piate and the back pla

Service air cleaner every 25 hours under normal conditions. Clean every few hours under extreme ly dusty conditions. Poor engine performance and

OFF-SEASON STORAGEIf the log splitter will not be used for a period longer than 30 days, the following steps should be taken to prepare the log splitt

HOW YOUR LOG SPLITTER OPERATESGear SectionTHE PUMPA two-stage log splitter pump has one large and one small gear section, using common inlet ant

HYDRAULIC TROUBLE SHOOTING GUIDEProbiemProbable Cause(s)Corrective ActionCylinder rod will not moveA Broken driveshaft B Loose shaft coupling C Gear s

Model 630NOTESpecifications subject to change without notice or obiigation.16

Model 630PARTS LIST FOR MODEL 630 LOG SPLITTERREF.NO.PARTNO.CODE DESCRIPTIONREF.NO.PARTNO.CODE DESCRIPTION1 712-0359Slotted Nut 3/4-16 Thd. 48 712-300

IMPORTANT INFORM/TION FOR LOG SPLITTER USERSALWAYS:Use clean fluid and check fluid level regularly Use Dexron II Automatic Transmission Fluid c r 10W

For Repiacement Parts, Contact:SERVICE DEPARTMENT • P.O. BOX 360900 • CLEVELAND, OHIO 44136

IMPORTANTRULES FOR SAFE OPERATIONATHIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH. IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL SAFETY AND

2. Know how to stop the unit and disengage the coni fols.3. Never place hands or feet between log and splitt hg wedge or between log and end plate d

ASSEMBLY INSTRUCTIONSTools Required for Assembly(1) Soft Hammer or Mallet(2) 9/16" Wrenches*(2) 1/2" Wrenches*(1) 7/16" Wrench*(1) Ad

FIGURE 3.6. Place one flat washer just removed on each axle. Secure with hex slotted nut. Tighten slotted nut until snug, then back off approx

ATTACHING THE WEDGE, BEAM AND CYLINDER ASSEMBLY1. Stand the wedge, beam and cylinder assembly upright, with cylinder to the top.ABeam Support/

PressureHoseFIGURE 10.Return Hose1. The return hose is attached to the top of the control valve. Loosen the hose clamp on the free end of the hose u

f. Refill the reservoir to within 1-1/2" to 2" from the top of the tank. Much of the original fluid has been drawn into the cy