DUSRR|,Soo-45S-70//LOG SPLITTERSMODEL NUMBERS PRO/20 (240-622-003) 424/LCD/22 (240-623-003)IMPORTANT:•Read this Manual Before Attempting to Assemble a
USING THE LOG SPLITTER Use the log splitter only on a level, hard surface. Never stand next to the splitting wedge 'vhen operating the log
3. Attach the hitch to a towing vehicie, making certain to latch securely. Attach the safety chains to the towing vehicle.ADJUSTMENT▲c V a * r n *ng
RESERVOIR FLUIDCheck the hydraulic fluid level in the log splitter reservoir tank before each use. Fluid level should b(! V/2" to 2" from t
NOTEMake certain proper clearance is tained before tightening set screw.PUMPob-FIGURE 18.—Bottom View TIRE PRESSURECheck sidewall of tire for manu
Trouble Shooting GuideTroublePossible Cause(!>)Corrective ActionEngine fails to start 1. Fuel tank empty, or stale fuel.2. Blocked fuel li ie.3.
HOW YOUR LOG SPUTTER OPERATESCylinderPilotPressureLinePumpReservoirHigh Volume Low Pressure Gear SectionLow Volume High Pressure Gear SectionTHE PUMPA
HYDRAULIC TROUBLE SHOOTING GUIDEProblemProbable Cs use(s)Corrective ActionCylinder rod will not moveA Broken driveshaft B Loose shaft couplir g C Gear
NOTES
PRO/20 (Model 622) 424/LCD/22 (Model 623)FOR. CiRCLOl rrEmS 5ee SuPPUE.»v)e.Kir fhfLcaRR-SCT Pact CP- DOiaNOTE: The engine is not under warranty by t
PRO/20 (Model 622) 424/LCD/22 (Model 623)PARTS LIST FOR MODELS 622 AND 623 LOG SPLITTERSREF.NO.PARTNO.CODEDESCRIPTIONREF.NO.PARTNO.CODEDESCRIPTION1712
FOR LOG SPLITTER USERSNEVER:Use fluid below 0° F., or above 150° F.Use a solid engine/pump coupling Force pump when mounting Operate through relief va
ONE YEAR UMITED WARRANTYNON-COMMERCIAL — NON-TRANSFERABLELimited to Modeis iFor one year from the date of original retail pi at its option, free of ch
IMPORTANTRULES FOR SAFE OPERATION▲THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL SAFETY AND/
▲2. Know how to stop the unit and disengage the controls.3. Never place hands or feet between log and splitting we dge or between log and end plate
IMPORTANTThis unit has been shipped without gasoline or oil in the engine. After assembly, refer to separate engine manual for proper
ATTACHING TONGUE TO RESERVOIR TANK1. The tongue is shipped with the jack stand already attached to the tongue. The jack stand is in the transport pos
ATTACHING THE ENGINE AND PUMP ASSEMBLY1.Using two 1/2" wrenches, remove the four hex bolts, lock washers and hex nuts which secure the bas
FIGURE 10.ATTACHING THE HOSES Suction Hose1. The suction hose is attached to the reservoir tank, beneath the engine mounting plate. Loosen the hose
c. Start engine. Use the control handle to extend the wedge to the far extended position. Leave the wedge in this position (do not retract).d. Refil
Comments to this Manuals