MTD OEM-190-821 Operator's Manual download pdf (Page 9)

Attaching The Seat

Seat styles vary by tractor model and there are three

different styles available:

• Standard Adjustment

• Quick Adjustment &

• Knob Adjustment

If the seat for your tractor did not come attached, refer

to Figure 3, Figure 4, and Figure 5 to identify your

tractor’s seat style and follow the applicable instructions

below to attach it.

NOTE: For shipping reasons, seats are either

fastened to the tractor seat’s pivot bracket with a plastic

tie, or mounted backward to the pivot bracket. In either

case, free the seat form its shipping position and

remove the two hex screws (or knobs, on models so

equipped) from the bottom of seat before proceeding

with applicable instructions below.

Standard Adjustment Seat

1. Position the shoulder screws (found on the base of

the seat) inside the slot openings in the seat pivot

bracket. Figure 3.

2. Slide the seat slightly rearward in the seat pivot

bracket, lining up the rear slots in the pivot bracket

with the remaining two holes in the seat’s base.

3. Select desired position for the seat, and secure with

the two hex screws removed earlier. See Figure 3.

Quick Adjustment Seat

NOTE: If your seat was shipped mounted backwards

on the seat pivot bracket, pull out the tab found on the

seat stop and hold it open while sliding the seat off the

seat pivot bracket. See Figure 4.

1. Line up the plastic seat spacers with the slots in

seat pivot bracket.

2. Slide seat in until front seat spacer engages the

seat stop. See Figure 4.

WARNING: Before operating this machine,

make sure the seat is engaged in the seat

stop, stand behind the machine and pull back

on seat until fully engaged into stop.

Knob

Adjustment Seat

1. Position the shoulder screws (found on the base of

the seat) inside the slot openings in the seat pivot

bracket. Figure 5.

2. Slide the seat slightly rearward in the seat pivot

bracket, lining up the rear slots in the pivot bracket

with the remaining two holes in the seat’s base.

3. Select desired position for the seat, and secure with

the two knobs removed earlier. See Figure 5.

Figure 3

Figure 4

Figure 5

Standard Adjustment

Hex Screws

Shoulder

Screws

Opening

in Slot

Pivot Bracket

Quick Adjustment

Seat Stop

Tab

Pivot Bracket

Knob Adjustment

Knobs

Shoulder

Screws

Opening

in Slot

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 51 52

Comments to this Manuals

No comments

MTD OEM-190-821 Operator's Manual Page 9

Comments to this Manuals

Related products and manuals for Lawnmowers MTD OEM-190-821