MTD OEM-190-821 Operator's Manual download pdf (Page 8)

SECTION 3: TRACTOR SET-UP

Attaching the Battery Cables

NOTE: The positive battery terminal is marked Pos.

(+). The negative battery terminal is marked Neg. (–).

• The positive cable (heavy red wire) is secured to

the positive battery terminal (+) with a hex bolt and

hex nut at the factory. Make certain that the rubber

boot covers the terminal to help protect it from

corrosion.

• Remove the hex bolt and wing nut from the

negative cable.

• Remove the black plastic cover, if present, from the

negative battery terminal and attach the negative

cable (heavy black wire) to the negative battery

terminal (–) with the bolt and wing nut.

• Make certain the hold-down strap is in position over

the battery, securing it in place. See Figure 1.

Figure 1

NOTE: If the battery is put into service after the date

shown on top of battery, charge the battery as

instructed on page 23 of this manual prior to operating

the tractor.

Gas and Oil Fill-up

The gasoline tank is located under the hood and has a

capacity of either two or three gallons. Do not overfill.

WARNING: Use extreme care when

handling gasoline. Gasoline is extremely

flammable and the vapors are explosive.

Never fuel machine indoors or while the

engine is hot or running. Extinguish

cigarettes, cigars, pipes, and other sources of

ignition.

Service the engine with gasoline and oil as instructed in

the separate Briggs & Stratton Operator/Owner Manual

packed with your tractor. Read instructions carefully.

IMPORTANT:

Your tractor is shipped with motor oil in the

engine. However, you MUST check the oil level before

operating. Be careful not to overfill.

Shipping Brace Removal

WARNING: Make sure the riding mower’s

engine is off, remove the ignition key, and set

the parking brake before removing the

shipping brace

• Locate the shipping brace, if present, and

accompanying warning tag found on the right side

of the mower, between the discharge chute and the

cutting deck. See Figure 2.

Figure 2

• While holding the discharge chute with your left

hand, remove the shipping brace with your right

hand by grasping it between your thumb and index

finger and rotating it clockwise.

WARNING: The shipping brace, used for

packaging purposes only, must be removed

and discarded before operating your riding

mower.

WARNING: The mowing deck is capable of

throwing objects. Failure to operate the riding

mower without the discharge cover in the

proper operating position could result in

serious personal injury and/or property

damage.

Rubber Boot

Hex Bolt

Wing Nut

Shipping Brace

Warning Tag

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 51 52

Comments to this Manuals

No comments

MTD OEM-190-821 Operator's Manual Page 8

Comments to this Manuals

Related products and manuals for Lawnmowers MTD OEM-190-821