$1.00OWNEirSGUM• ASSEMBLY • OPERATION • MAINTENANCE • PARTS •5 and 8 H.P. SHREDDERSModel Numbers 243-645C000 243-648C000(Model 64SC Shown)Important:Re
Models 645CANID648C10
Models 645C and 648CPARTS LIST FOR SHREDDERSREF.NO.PARTNO.CODEDESCRIPTIONREF.NO.PARTNO.CODEDESCRIPTION1742-0571Blade39710-3008Hex Bolt 5/16-18 X .75&q
TROUBLE SHOOTINGPROBLEMPOSSIBLE CAUSE(S)CORRECTIVE ACTIONEngine fails to start1. Spark plug wire disconnected.2. Fuel tank emph , or stale fuel.3.
SiAFETY RULESAWARNING: TO REDUCE THE PC TENTIAL FOR ANY INJURY, COMPLY WITH THE FOLLOWING SAFETY INSTRUCTIONS. FAILURE TO COMPLY WITH
ASSEMBLY INSTRUCTIONSAHACHINGTHE UPPER GUIDE ASSEMBLYFlat Washer 5/16" I.D.Hex Lock Nut 5/16-18 ThreadHex Bolt-5/16-18 X 8-3/8" LongBIMPORTA
AWARNING: Make certain the spaijk plug wire is disconnected and moved away from the spark plug before asseinbling the shredder.HousingH
AHACHING THE CATCHER BAGYour shredder is equipped with a catcher bag to catch the shredded material.To attach the bag, place the opening of the bag ov
BEFORE STARTING1. Place the shredder on a firm, level surfac j.2. Service engine with gasoline and oil as ir structed in the separate engine manual
FIGURE 9.3.To lower the hopper assembly, use one hand to grasp the handle at the top of the hopper assembly and lift slightly. Pull up on the release
mended at the start of each season; check engine manual for correct plug type and gap specific ations.Clean the engine regularly with a
NOTE: When reassembling, make certain the opening on the back-up plate is toward the bottom of the unit. The back-up plate may be reversed to
Comments to this Manuals