$1.00OWNEirS GUIDEASSEMBLY • OPERATION • MAINTENANCE • PARTS13 TON Model NumberHORIZONTAL 249-610-000LOG SPLITTERImpOltant: Read Safety Rules and Ins
NOTEA DIRTY AIR CLEANER WILL CAUSi; ENGINE TO RUN ROUGH. BE CERTAir 1 AIR CLEANER IS CLEAN AND ATTACHED TO THE CARBURETOFt BEFORE ADJUSTIN
Trouble Shooting GuideT roublePossible Cause(s)Corrective ActionEngine fails to start1. Fuel tank empty, or stale fuel.2. Blocked fuel line.3. Spar
Model 610i4oLL i N''“50 /VS/<c' '>'‘-jR'S of )f~NOTESpecifications subject to change without notice or obligation.
Model 610PARTS LIST FOR MODEL 610 LOG SPLITTERREF.NO.PARTNO.CODEDESCRIPTIONREF.NO.PARTNO.CODEDESCRIPTION1 781-0038Wedge Ass’y-37712-0203Hex Nut 3/4-10
PARTB INFORMATIONPOWER EQUIPMENT PARTS AND SERVICEParts and service are available through the authorized service firrr s iisted below. All orders shou
IMPORTANTRULES FOFi SAFE OPERATIONATHIS SYMBOL POINTS OUT IMPORTANT SAFETY INS' RUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL SAFE
2. Know how to stop the unit and disengage the controis.3. Never place hands or feet between iog and splitting wedge or be- k, tween iog and ram dur
IMPORTANTThis unit has been shipped without gasoline or oil in the engine. After assembly, refer to separate engine manual for proper
FIGURE 3.LockINSTALLATION OF WHEELS1. Using a flat blade screwdriver, pry off the hub caps which are attached to the wheels. Remove one tapered rol
devis I *in Cotter l’in2.Place the hitch in position on the beam stand as shown in figure 6. Place spacer (L) inside the beam stand. Insert hex bolt
d. Stop the engine. Remove the fluid check plug. Add fluid as necessary until fluid starts to come out of the hole. Replace the check plug.e. Repeat
TO OPERATE LOG SPLITTER:1. Set throttle at maximum speed.2. Place log on beam. Hold in piace with hand.3. Slowly move control handle forward until
BEAM AND SPLITTING WEDGELubricate the beam where it contacts the ram with grease before each use to obtain years of service.HOSE CLAMPSCheck t
Comments to this Manuals