.50ASSEMBLY » OPERATION « MAINTENANCE » PARTS22" ROTARY MOWERSImportant:Read Safety Rules and Instructions CarefullyThank you for purchasing an A
FIGURE 13.SPARK PLUGThe spark plug should be cleaned (see figure 12) and the gap reset to a 0.030-inch clearance once a season (see figure 13). Spark
NOTEThe manufacturer DOES NOT recommend the use of any accessory on this Rotary Mower other than those manufactured by the mower manufacturer.GRASS CA
111-902A111-902-026IF YOU WRITE TO US ABOUT THIS ARTICLE OR IF YOU ORDER REPLACEMENT PARTS ALWAYS MENTION THIS MODEL & SERIAL NO MODEL
111-902A 111 -902-026PARTS LIST FOR 111-902A AN D 111 -902-026REF.NO.PARTNO.COLORCODEDESCRIPTIONNEWPARTREF.NO.PARTNO.COLORCODEDESCRIPTIONNEWPART1710-0
PARTS INFORMATIONPOWER EQUIPMENT PARTS AND SERVICEParts and service for all MTD manufactured power equipment are available through the authorized
INDEXSafe Operation Practices...3Assembly Instructions...4Operation...
^ WARNING \To reduce the potential for any injury, comply with thethe instructions may result in personal injury.SAFE OPERATION PRACTICESTRAINING1. I
LowerHandleInnerHoleOuterHoleWeld PinFIGURE 1.ASSEMBLYINSTRUCTIONSNOTEThis unit is shipped WITHOUT GASOLINE or OIL. After assembly, see operatin
CableFIGURE 4.\Chute DeflectorShipping Block ^ To Be RemovedFIGURE 5.5. Secure throttle control cable to handle with — ties provided. See figur
OPERATIONCAUTIONDO NOT OPERATE MOWER UNLESS GUARD OR ENTIRE GRASS CATCHER IS IN ITS PROPER PLACE.Keep hands and feet away from the chute area o
Low Position High PositionFIGURE?.THROTTLEIf adjustment becomes necessary, the throttle control wire assembly can be reset as follows:1. Loosen,
CUTTING BLADEA. Removal for Sharpening or ReplacementFIGURE 9.LUBRICATIONIMPORTANTAlways stop engine and disconnect spark piug wire before cleani
Blade Mounting Torque3/8" Dia. Bolt 375 in. ib. min., 450 in. lb. max.5/16" Dia. Boit 150 in. ib. min., 250 in. Ib. max.To insure safe op
Comments to this Manuals