CUTTING BLADE
A. Removal for Sharpening or Replacement
FIGURE 9.
LUBRICATION
IMPORTANT
Always stop engine and disconnect
spark piug wire before cleaning,
iubricating or doing any kind of
work on lawn mower.
Wheels—The wheels require no lubrication.
However, if the wheeis are removed for any
reason, iubricate the surface of the axle bolt and
the inner surface of the wheel with light oii. A4oz.
plastic bottle of light oil lubricant is available.
Order part number 737-0170. Engine oil may also
be used.
Protective Shield—The pivot points on the protec
tive shield should be lubricated periodically with
light oil to prevent any rust or binding.
Chute Deflector—The torsion spring and pivot
point should be lubricated periodically with light
oil to prevent any rust or binding. Deflector must
work freely.
Engine—Follow engine manual for lubrication in
structions.
Throttle—Periodically lubricate throttle control
lever and throttle wire assembly with a few drops
of light oil for ease of operation.
MAINTENANCE
\ WARNING {
Disconnect spark plug wire and
ground it against the engine be
fore performing any repairs or main
tenance.
I WARNING {
Be sure to disconnect and ground
the spark plug wire before working
on the cutting blade to prevent
accidental engine starting.
1. Remove the large bolt and lock washer which
holds the blade and adapter to the engine
crankshaft.
2. Remove the blade and adapter from the
crankshaft. Be careful not to lose the key on
the crankshaft.
3. If the blade or blade adapter needs replacing,
remove the two small bolts, lock washers and
nuts which hold the blade to the adapter.
B. Sharpening
Remove the cutting blade by following the direc
tions of the preceding section.
When sharpening the blade, follow the original
angle of grind as a guide. It is extremely important
that each cutting edge receives an equal amount
of grinding to prevent an unbalanced blade. An un
balanced blade will cause excessive vibration
when rotating at high speeds and may cause
damage to the mower.
The blade can be tested for balance by balancing
it on a round shaft screwdriver. Remove metal
from the heavy side until it balances evenly.
NOTE
It is recommended that the blade
always be removed from the adapter
for the best test of balance.
C. Reassembly
Before reassembling the blade and the blade
adapter to the unit, lubricate the engine
crankshaft and the inner surface of the blade
adapter with light oil. Lubricating the bolt holes,
bolts and inner surface of the nuts with light oil is
also recommended. A 4 oz. plastic bottle of light
oil lubricant is available. Order part number
737-0170. Engine oil may also be used.
When replacing the blade, be sure to install the
blade with the side of the blade marked “Bottom”
(or with part number) facing the ground when the
mower is in the operating position. Make certain
key is in place on the crankshaft.
(16 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals