Mtd 249-623-003 User Manual

DUSRRLOG SPLITTERMODEL NUMBER 424/LCD/22 (249-623-003)IMPORTANT:•Read this Manual Before Attempting to Assemble and Use•Read Safety Rules and Ins

c.d.e.Start engine. Use the control handle to 3xtend the wedge to the far extended position. Leave the wedge in this position (do not re

AWARNING3. Retighten the three hex bolts on top of the slide plate.If the fluid becomes excessively hot at any time during operation, stop

RESERVOIR FLUIDCheck the hydraulic fluid level in the log splitter eser- voir tank before each use. Fluid level should be 1V2"

NOTEMake certain proper clearance is obtained before tightening set screw.PUMPTIRE PRESSURECheck sidewall of tire for manufacturer’s recom

Trouble Shooting GuideTroublePossible Cause(s|Corrective ActionEngine fails to start1. Fuel tank empty, or stale fuel.2. Blocked fuel life.3. Spark

HOW YOUR LOG SPLITTER OPERATESCylinderCylinderDirectionalValveRelief ValveBreatherCap Unloading Jl--, ValvePilotPressureLinePumpReservoirHigh Volume L

HYDRAULIC TROUBLE SHOOTING GUIDEProblem Probable Cau!>e(s)Corrective ActionCylinder rod wjll not moveA Broken driveshaft B Loose shaft coupling C G

424/LCD/22 (Model 623) Pft¿:s^uR£30ÛÛ то 3<3.ûû FS I Î1

424/LCD/22 (Model 623)PARTS LIST FOR MODEL 623 LOG SPLITTERREF.NO.PARTNO.CODEDESCRIPTIONREF.NO.PARTNO.CODEDESCRIPTION1 712-0299Hex Castle Nut 3/4-16 T

18 MONTH LIMITED WARRANTYNON-COMMERCIALNON-TRANSFERABLELimited to Models PRO/20 and 424/LCD/22 Log SplittersFor 18 months from the date of orig

IMPORTANT INFORMATION FOR LOG SPLITTER USERSNEVER:Use fluid below 0° F., or above 150° F.Use a solid engine/pump coupling Force pump when mounting Ope

IMPORTANTRULES FOR SAFE OPERATIONATHIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL SAFETY AND/

A2. Know how to stop the unit and disengage the con :rols.3. Never place hands or feet between log and splitting wedge or between log and end plate

IMPORTANTThis unit has been shipped without gasoiine or oil in the engine. After assembiy, refer to separate engine manual for proper

Hex NutsBeam Support/INSTALLING THE HITCH1. Using two 9/16" wrenches, remove the two long hex bolts, lock washers and hex nuts whi

ATTACHING THE ENGINE AND PUMP ASSEMBLY1. Using two V2" wrenches, remove the four hex bolts, lock washers and hex nuts which secure

'ControlValveFilterHeadReservoir TankFIGURE 10.*umpSuctionHoseControlValveMetalPressureTjbeFIGURE 11.ATTACHING THE HOSES Suction Hose1. The suc

TO STOP ENGINE1. Move throttle control lever to OFF position.2. Disconnect spark plug wire from spark plug to prevent accidental starting