Mtd 249-623-003 User Manual download pdf (Page 5)

IMPORTANT

This unit has been shipped without

gasoiine or oil in the engine. After

assembiy, refer to separate engine

manual for proper fuel and engine oil

information.

„ . . „ Beam Support/

Engine and Reservoir Latch Bracket

Pump Assembly Tank Assembly I

Beam

Hinge

Bracket

ASSEMBLY

Wedge, Beam and

Cylinder Assembly

-Hitch

Assembly Tongue Assembly

s FIGURE 1.

UNPACKING

Remove the log splitter parts from the cartons by cut

ting the corners of the cartons. Make certain all parts

and literature have been removed from the cartons

before the cartons are discarded.

All hardware for assembly of the log splitter has been

placed in position on the various parts.

-Parts in Cartons (See figure 1)

Carton marked 1 of 2:

Reservoir Tank Assembly

Engine and Pump Assembly (Bolted to bottom of

carton)

Beam Hinge Bracket

Fenders (Not Shown)

Carton marked 2 of 2:

Tongue Assembly

Wedge, Beam and Cylinder Assembly

Hitch Assembly

Beam Support/Latch Bracket

Tools Required for Assembly

(2) 9/16" Wrenches*

(2) 1/2" Wrenches*

(1) Adjustable Wrench

(1) Knife (to remove cable tie)

(1) Screwdriver

*Adjustable Wrenches may be used.

Other Materials Required for Assembly:

Engine Oil

Unleaded Gasoline (regular grade gasoline is an

acceptable substitute)

Approximately 7.6 Gallons of Dexron II Automatic

Transmission Fluid

ATTACHING TONGUE TO RESERVOIR TANK

—1. The tongue is shipped with the jack stand already

attached to the tongue. The jack stand is in the

transport position. Remove the quick release pin.

Pivot the jack stand to the operating position (90°),

and secure with the quick release pin. See figure 2.

2. Remove the two hex bolts, lock washers and hex

nuts on the front of the reservoir tank. Two 9/16"

wrenches are required. Place the tongue in posi

tion, and secure with hardware just removed. See

figure 3.

1 2 3 4 5 6 7 8 9 10 ... 18 19

Comments to this Manuals

No comments

Mtd 249-623-003 User Manual Page 5

Comments to this Manuals

Related products and manuals for Tools Mtd 249-623-003