Mtd 195-746-000 User Manual download pdf (Page 4)

ASSEMBLY (V)

B. Next, slide the idler bracket assembly (V)

over the idler bracket support arm. Secure

with spirol pin (I). See figure 4.

FIGURE 4

HAIRPIN

COTTER

FIGURE 5

HEX BOLT (E)

Remove the two hairpin cotters on the rear of

your tractor. See figure 5. These will be re

assembled to your unit in steps 4 and 9.

Place the support pivot bracket (with idler bracket

and support arm attached) in position on the

rear left hand side of tractor. Place large hole in

pivot bracket over shaft on tractor. Secure with

one hairpin cotter removed in step 3.

FIGURE 6

Thread one hex nut (O) all the way onto hex

bolt(M) (1-1/2" long).

Place the support pivot bracket in position so the

forward hole (larger) in the bracket aligns with

the larger hole in the tractor frame.

Secure the support pivot bracket to the tractor

by placing hex bolt (M) (with nut assembled) in

the smaller hole in plate which aligns with hole

on tractor. Start hex nut (0) and lock washer

(N) by hand. See figure 6.

Place one hex bolt (E) through top forward

hole in bracket and tractor frame. Secure with

lock washer (F) and hex nut (G).

Assemble the other support pivot bracket to

the right hand side of tractor in the same manner,

except use hex bolt (H) (1" long) instead of the

longer hex bolt and the extra hex nut.

10. Tighten securely all four nuts and bolts which

were used in assembly of pivot support brackets.

11. Secure end of idler bracket support arm assembly

on the right side of tractor with one flat washer

(D) and hairpin cotter (J).

1 2 3 4 5 6 7 8 9 ... 15 16

No comments

Mtd 195-746-000 User Manual Page 4