Mtd 110-428R000 User Manual

$1.00OWNEirS GUIDEASSEMBLY • OPERATION • MAINTENANCE • PARTS21"ROTARYMOWERS(Model 426R Shown) QJ& Qj KTC HER»' (Sbfx)Q76,Model Numbers11

Locking Lever“Star” Washer5. Assemble the locking lever as follows:a. Place wave washer on shoulder bolt (crowned side of washer goes against the he

OPERATIONTO REDUCE THE RISK OF INJURY, DO NOT OPERATE MOWER UNLESS REAR TRAILING SHIELD AND THIS GUARD OR ENTIRE GRASS CATCHER IS IN ITS PROPER P

AWARNING: The blade continues to rotate for a few seconds after the engine is shut off.2. Disconnect the spark plug wire and ground it against

2.3.Place the throttle control lever on the handle all the way forward to START position.Place the control lever on the engine in the full open positi

bell washer which hold the blade and adaptei to the engine crankshaft. Remove the blade and adapter from the crankshaft.If the blade or blade adapter

TROUBLE SHOOTING GUIDET roublePossible Cause(s) Corrective ActionEngine fails to starti.1. Blade control handle disengaged.2. Spark plug wire discon

Models 41 OR thru 429RA?a:H£U. USES7^1-OSS^ 7o.S“ /£LLSaJThis instruction manual covers various models and all specifications shown do not necessari

Models 41 OR thru 429RPARTS LIST FOR MODELS 41 OR THRU 429R ROTARY MOWERSilEF.NO.PARTNO.CODEDESCRIPTIONREF.NO.PARTNO.CODE DESCRIPTION1747-0748 N Contr

PARTS LIST FOR MODELS 410 THRU 429R ROTARY MOWERS (CONTINUED)REF.NO.PARTNO.CODE DESCRIPTION86720-0190Spring Lever Knob87732-0417ASpring Lever88 16106R

PARTS INFORMATIONPOWER EQUIPMENT PARTS AND SERVICEParts and service are available through the authorized service firms listed below. All orders should

INDEXSlope Gauge... 3Contents of Hardware Pack...4Rules f

------ ------------------------------------------------------------------------------- Cut Along This Line--------------------------------------------

CONTENTS OF HARDWARE PACK/PARTS IDENTIFICATIONRemove this sheet from your owner’s manual £ nd lay the hardware on the illustration for identification

IMPORTANTRULES FOR SAFE OPERATIONTHIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL SAFETY AND/O

ASSEMBLY INSTRUCTIONSIMPORTANT: This unit is shipped WITHOUT GASOLINE or OIL. After assembly, service engine with gasoline and oil as instructed

AHACHING THE THROTTLE CONTROL (Hardware C)The throttle control is attached to the engine. Attach the throttle control to the left side of upper handle

FIGURE 7.—Optional Hub CapsINSTALLATION OF HUB CAPS (Optional)1. If your mower is equipped with hub caps which have four tabs, line up the tabs on th

Models 420R through 429R (Hardtop Grass Bags):1. There are three holes in the rear frame. With the ------holes on the upper side as shown in figure 9