OUTDOOR POWER EQUIPMENT for all seasonsImportant:Read Safety Rules and Instructions Carefully3-1/2 H.P. LOG SPUTTERModel Numbers 245-638-000 24638S
FIGURE 13FIGURE 155. Using a 9/16" wrench, remove the engine pu ley by removing the hex bolt and lock washer. See figure 14. Sli
TROUBLE SHOOTING CHARTSYMPTOMPOSSIBLE CAUSE (S)SOLUTION^ Engine fails to startA. Check fuel tank for gas.B. Spark plug lead wiredisconnected.C. Fau
Model 638IF YOU WRITE TO US ABOUT THIS AftllClE OR IF YOU ORDER REPLACEMENT PARTS ALWAYS MENTION THIS MODEL & SERIAL NO MODELNOTEThis instruction
Model 638PARTS LIST FOR MODEL 638 LOG SPLITTERi>lO.PARTIMO.COLORCODEDESCRIPTIONNEWPARIREF.NO.PARTNO.COLORCODEDESCRIPTIONNEWPART1717-08162-1/2"
Model 6381&22-1/2" DIA. CYLINDER PARTS LIST FOR MODEL 638REF.NO.PART NO. DESCRIPTIONNEWPART1 717-0816C\ linder Ass'y- Comp.N2 753-0392 2
MTD PRODUCTS INC ... YSRO-MSN COMPANYP.O. BOX 3690D • CLEVELAND OHIO 44136
INDEXSafe Operation Practices... 3Assembly Instructions... 5Ope
AIMPORTANTIt is suggested that this manual be read in its entirety before attempting to assemble or operate. Keep this manual -*cka safe place for fut
11. Never attempt to split wood across the. g ain. Some types of wood may burst or fly out of your splitter and result in injur
G-H-FIGURE 1ASSEMBLY INSTRUCTIONSTOOLS REQUIRED(1) Raw Hide or Plastic Hammer (1) 3/4" Wrench or Adjustable Wrench (1) Pair of PliersOTHER MATERI
LEFT HAND SIDE OF SPLITTERFIGURE4Slide spacer (J) onto axle shaft on the left hand side of the splitter. Spacer should be on the engine side
9. Place the flattened end of the engagement handle (0) down through the slotted bracket beside the beam. Place shoulder bolt (A)
NOTEDO NOT operate log splitter without proper amount of oil in reservoir tank (beam).2. Fill sump with oil as instructed in the s
AI WARNING JNever attempt to cut a log in half with the log splitter.Never stand next to the ram when operating. Always stand behind theram.MAINTENANC
Comments to this Manuals