Mtd 242-632-000 User Manual

$1.00OWNER’S GUIDE• ASSEMBLY • OPERATION • MAINTENANCE • PARTS •VERTICAL LOG SPLITTERSModel Numbers 242-622-000 (5 H.P. 20 Ton) 242-632-000 (5 H.P. 22

REVERSE—Push the control handle upward for vertical operation, push it toward the rear for he rizontal operation—Splitting wedge ret

Hex BoltsBoltsthe bottom of the reservoir tank, and drain the fluid into a suitable container. Refill using only Dexron II automatic

The spark plug should be cleaned and the gap reset once a season. Spark plug replacement is ecom- mended at the start of each se

TROUBLE SHOOTING GUIDETrouble Possible Cause(s) Corrective ActionEngine fails to start 1. Fuel tank empty, or stale fuel.2. Blocked fuel line.3. Sp

HOW YOUR LOG SPUTTER OPERATES______ ?i 1ÌU--- ----- ----- ----- ---Bs ;sa--- -- ----- ------ ^DirectionalValveRelief ValveBreather Cap Unloading Valve

HYDRAULIC TROUBLE SHOOTING GUIDEProblem Probable Cause(s) Corrective ActionCylinder rod will not moveA Broken driveshaft B Loose shaft coupling C Gear

Models 622 and 6<\2NOTESpecifications subject to change without notice or obligation.NOTE: The engine is not under warranty by the log splitter man

Models 622 and 632PARTS LIST FOR MODELS 622 AND 632 LOG SPLITTERSREF.NO.PARTNO.CODEDESCRIPTIONREF.NO.PARTNO.CODEDESCRIPTION1 712-0359 Slotted Nut 3/4-

IMPORTANT INFORMATION FOR LOG SPLITTER USERSALWAYS:Use clean fluid and check fluid level regularly Use Dexron II Automatic Transmission Fluid or low n

FOR REPLACEMENT PARTS, CONTACT:SERVICE DEPARTMENT • F.O. BOX 360900 • CLEVELAND, OHIO 44136

IMPORTANTRULES FOR SAFE OPERATION4THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL SAFETY AND

2. Know how to stop the unit and disengage the control >.3. Never place hands or feet between log and splitting wedge or between log and end plat

ASSEMBLY INSTRUCTIONS(2)(2)(1)(1)(1)Tools Required for Assembly(1) Soft Hammer or Mallet 9/16" Wrenches*1/2" Wrenches*Adjustable Wrench Scre

9.Check the assembly of the wheels. There should be no side to side play, and the wheel should spin freely.Place hub caps in posit

AHACHING THE BEAM SUPPORT/LATCH BRACKET1. Remove the two hex bolts, lock washers and hex nuts from the tongue, using two 9/16" wrenches.

FIGURE 10.PressureHoseFIGURE 11.ATTACHING THE HOSESSuction Hose1. The suction hose is attached to the reservoir tank, beneath the engine m

c. Start engine. Use the control handle to extend the wedge to the far extended position. Leave the wedge in this position (do not retr