MTD E46J Specifications download pdf (Page 10)

The rope guide is attached to the right side of the upper

handle. See Fig. 3-3. Loosen the wing nut which secures the

rope guide.

Slip plastic channel of grass bag over hooks on the

frame. See Fig. 3-4. All the plastic channels except

center top of bag attach from outside of frame.

Figure 3-3

a. Hold blade control against upper handle.

b. Pull starter rope out of the engine. Release blade

control.

c. Slip starter rope into rope guide.

d. Tighten wing nut.

Insert post on cable tie into hole provided on the lower

handle. Pull cable tie tight and trim excess.

GrassCatcher

Follow steps below to assemble the grass catcher. Make

certain bag is turned right side out before assembling

(warning label will be on the outside).

a. Place bag over fra me so that its black plastic side is

at the bottom.

Figure 3-4

c. Attach center top of bag from inside of frame.

Follow the steps below to attach the grass catcher:

a. Lift rear discharge door. See Fig. 3-5.

Figure 3-5

Place grass catcher on the pivot rod. Let go of

discharge door so that it rests on the grass catcher.

WARNING: Never operate mower unless the hooks

on the grass catcher are firmly seated on the pivot

rod and the rear discharge door rests firmly against

top of the grass catcher.

SECTION 3 -- ASSEMBLY& SET-UP

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

No comments

MTD E46J Specifications Page 10