MTD 584 Operations Instructions download pdf (Page 60)

Figure 2-1.. Load Terminals

Figure 2-1.

Figure 2-2.

TM 5-6115-584-12

NAVFAC P-8-622-12

TO-35C2-3-456-1

TM-05682C-12

Table 2-1. Generator Set Controls and Instruments (Cont)

Control Description

Function

OIL PRESSURE

Located on oil fill side of engine.

Indicates engine oil pressure.

GAUGE

0-50 pounds per square inch (psi)

RECONNECTION

Located on output control box.

Used

to select 120V, 1 phase; 120/240V, 1 phase; or

SWITCH

Three position rotary switch.

120/208V, 3 phase output for Generator Set.

c. Place master switch in START position and

hold until engine comes to operating speed. If engine

does not start within 15 seconds repeat steps b and c.

NOTE

If engine does not come to operating speed

within 15 seconds, a minimum of 30

seconds cooling period must be observed

before attempting another start.

d. Master switch will return to PRIME & RUN

position when released. If running from auxiliary fuel

source, move master switch to PRIME & RUN AUX.

FUEL position.

e. Check oil pressure on engine mounted gauge. Oil

pressure should be at least 20 psi minimum. Check

frequency on frequency meter on control panel and

adjust governor if necessary, using speed control.

Frequency meter should read 61.5 with no load. Pull-

ing speed control knob out will increase frequency,

Change 6

2−32−3

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 236 237

No comments

MTD 584 Operations Instructions Page 60