Mtd TMO-33849A User Manual download pdf (Page 6)

CHUTE ASSEMBLY (Al)

NOTE

Before setting the chute assembly on

the spiral housing assembly, grease the

housing for ease of operation. See

figure 7.

7. Assemble the chute assembly (Al) to the housing

using three chute flange keepers (Y) and six hex

lock nuts (X). See figure 7.

FIGURE 7

IDLER PULLEY

FIGURES

■8. Place the 85" belt (A) in position on the idler of

the snow thrower as shown in figure 8.

NOTE

The idler bracket has three holes for

belt tension adjustment. Normally, the

idler pulley is assembled in the center

hole. If the belt is too tight to

assemble, the idler pulley may be

moved to the top hole.

PREPARING THE LAWN

TRACTOR FOR ASSEMBLY

OF SNOW THROWER

1. Remove the gas cap and place a piece of plastic

film on the gas cap to prevent gas from leaking out

of the tank.

NOTE

If unit is electric start remove the

battery.

2. Remove the spark plug wire from spark plug and

grounrd.

3. Remove the mowing deck.

4. With a piece of wire hold the front left hand deck

hanger out of the way. See figure 9.

NOTE

This hanger bracket is straight.

FIGURE 9

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

No comments

Mtd TMO-33849A User Manual Page 6