Mtd K Style User Manual download pdf (Page 7)

Assembly

Handle

Place the shift lever in the Forward-6 position1.

Observe the lower rear area of the snow thrower to be sure 2.

both cables are aligned with roller guides before pivoting

the handle upward. See Fig. 3-1.

NOTE: Make certain the upper ends of each cable are

seated properly in its bracket.

Secure the handle by tightening the plastic knob located 3.

on both the left and right sides of the handle. Remove

and discard any rubber bands, if present. They are for

packaging purposes only.

Chute Assembly

Remove wing nut and hex screw from chute control assembly 1.

and clevis pin and cotter pin from chute support bracket.

Position the chute assembly (forward-facing) over the

chute base. See Fig. 3-2.

Place chute assembly onto chute base and secure chute 2.

control assembly to chute support bracket with clevis pin

and cotter pin removed earlier. See See Fig. 3-3.

Figure 3-3

Contents of Carton

One Snow Thrower• Two Replacement Auger Shear Pins• One Product Registration Card•

One Snow Thrower Operator’s •

Manual

Figure 3-1

Figure 3-2

Assembly & Set-Up

1 2 3 4 5 6 7 8 9 10 11 12 ... 31 32

No comments

Mtd K Style User Manual Page 7