Mtd K Style User Manual download pdf (Page 23)

Slip the drive belt off the pulley and between friction 6.

wheel and friction wheel disc. See Fig. 8-7.

Remove and replace belt in the reverse order.7.

NOTE: Engaging the drive control will ease reassembly of

the belt.

Friction Wheel Removal

If the snow thrower fails to drive with the drive control engaged,

and performing the drive control cable adjustment fails to

correct the problem, the friction wheel may need to be replaced.

Follow the instructions below. Examine the friction wheel for

signs of wear or cracking and replace if necessary:

Allow the engine to run until it is out of fuel.1.

Place the shift lever in third Forward (F3) position.2.

Carefully pivot the snow thrower up and forward so that it 3.

rests on the auger housing.

Remove the frame cover from the underside of the snow 4.

thrower by removing four self-tapping screws which secure

it. Remove the right-hand wheel by removing the screw

and bell washer which secure it to the axle. See Fig. 8-8.

Figure 8-7

Figure 8-8

23se c t i O n 8 — se r v i c e

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

No comments

Mtd K Style User Manual Page 23