Safety • Assembly • Operation • Maintenance • Troubleshooting • Parts Lists • WarrantyWarning: This unit is equipped with an internal combustion engin
10Gas & Oil Fill-Up Service the engine with gasoline and oil as instructed in the Tecumseh Engines manual packed separately with your snow thrower
114. Move throttle control to STOP position.5. Remove the ignition key and store in a safe place.6. Wipe all snow and moisture from the area around
125MakingAdjustmentsAuger ControlRefer to Auger Control Test on Page 11 to adjust the auger control.Drive ControlWhen the drive control is released an
135Making AdjustmentsWARNINGLoose gravel can be picked up and thrown by the auger, causing injury to the operator and bystanders and/or damage to the
146Maintaining Your Snow ThrowerWARNINGBefore lubricating, repairing, or inspect-ing, disengage all controls and stop engine. Wait until all moving pa
156Maintaining Your Snow ThrowerAuger Belt ReplacementTo remove and replace your snow thrower’s auger belt, proceed as follows:1. Remove the plastic
16Augers• The augers are secured to the spiral shaft with two shear pins and cotter pins. If the auger should strike a foreign object or ice jam, the
17Friction Wheel RemovalIf the snow thrower fails to drive with the drive control engaged, and performing the drive control cable adjust-ment on page
187Off-Season StorageNever store snow thrower with fuel in tank indoors or in poorly ventilated areas, where fuel fumes may reach an open flame, spark
19NOTE: This section addresses minor service issues. For further details, contact a MTD authorized service center or call 1 (800) 800-7310 for assista
2Finding and Recording Model NumberPlease do NOT return the unit to the retailer from which it was purchased, without first contacting Customer Suppor
20 Styles C & D
211. 731-2635 Snow Removal Tool Mount2. 684-04057 Impeller Assembly, 12” Dia.3. 710-0347 Hex Screw, 3/8-16, 1.75, Gr54. 710-0451 Bolt, Ca
22 Styles C & D
231. 631-04133 Handle Ass’y, Lock LH2. 631-04134A Handle Ass’y, Lock, RH3. 684-04106A Handle Ass’y, Engagement LH4. 684-04105A Handle Ass’y, Engagemen
24 Styles C
251. 756-04177 Disc, Friction Wheel 2. 684-04153 Friction Wheel Assembly, 5.5 OD 3. 684-04154 Support Bracket, Friction Wheel 4. 684-041
NOTES26
NOTES27
The limited warranty set forth below is given by MTD LLC with respect to new merchandise purchased and used in the United States, its posses-sions and
31Safety LabelsWARNINGThis symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property
42Safe Operation PracticesTraining1. Read, understand, and follow all instructions on the machine and in the manual(s) before attempting to assemble
5Operation1. Do not put hands or feet near rotating parts, in the auger/impeller housing or chute assembly. Contact with the rotating parts can amput
63Setting Up Your Snow ThrowerNOTE: References to right or left side of the snow thrower are determined from behind the unit in the operating position
73Setting Up Your Snow Thrower5. Remove the flat washer and hairpin clip from the end of the chute directional control. Insert the end of the chute
84Operating Your Snow ThrowerNow that you have set up your snow thrower for operation, get acquainted with its controls and fea-tures. These are descr
94Operating Your Snow ThrowerWARNINGThe operation of any snow thrower can result in foreign objects being thrown into the eyes, which can damage your
Comments to this Manuals