Mtd 214-031-000 User Manual

OWNERSMANUAL.75CHAINDRIVETILLERASSEMBLY OPERATION MAINTENANCE PARTS LISTModel Number 214-031-000Important:Read Safety Rules and Instructions Carefully

CLUTCH ADJUSTMENTRefer to step numbers 8 and 9 of Assemlily Instructions for clutch adjustment informatici.CARBURETOR ADJUSTMENT^ WARNING \I

FIGURE 20.OFF SEASON STORAGEIf the tiller is not to be used for a while, the following procedure should be followed. The tines, depth bar, ch

TROUBLIE SHOOTING CHARTSYMPTOMPOSSIltLE CAUSE(S)SOLUTIONEngine fails to start1. Check uel tank for gas.2. Spark plug lead wirediscc nnected.3. Faul

Chain Case Assembly 04924 Model 031Lubricate with 10 oz. of Piasti- iube #0 Grease. Order Part No. 737-0133.PARTS LIST FOR CHAIN CASE ASSEMBLY 0^1924R

Model 031IF YOU WRITE TO US ABOUT THIS ARTICIE OR IF YOU ORDER REPLACEMENT PARTS ALWAYS MENTION THIS MODEL & SERIAL NO MODEL

Model 031PARTS LIST FOR MODEL 031 TILLERREF.NO.PARTNO.COLORCODEDESCRIPTIONNEWPARTREF.NO.PARTNO.COLORCODEDESCRIPTIONNEWPART1720-0204Grip33 04922 Tine B

PARTS INFORMATIONPOWER EQUIPMENT PARTS AND SERVICEParts and service are available through the authorized service firms listed below. All order

INDEXSafe Operation Practices...3Assembiy Instructions... 4Operation...

J WARNING ITo reduce the potential for any injury, comply with the following safety instructions. Failure to comply with the instructions may result i

ASSEMBLYFIGURE 1.Right Hand Upper Handle^ Left HandUpper HandleNOTEThis unit is shipped WITHOUT GASOLINE or OIL. After assembly, see separate

Carriage Boit (A)4. Place the handle panel in position on the upper handies. Secure in position with four carriage bolts (A), lock washers (B) and

• .iliihr ^ Ï-» ci^4 :LockWasherSlot in Cable Support Bracket7.Remove one hex nut and lock washer from end of clutch cable. Slip the wire up t

FIGURE 9.11. Secure the clutch cable to the upper handle with cable tie (D) provided in hardware pack. ------See figure 9. Cut off excess end.OPERATIO

6. After engine starts, push choke knob gradually in to “OFF” position.NOTEWarm engine should not need choking.iiii Ui:' '> r.Chok

DEPTH BAR ADJUSTMENTThe working depth of the tiller is determined by the position of the depth bar. Remove the clevis pin and internal co