Mtd 465 User Manual download pdf (Page 5)

WARNING: - YOUR RESPONSIBILITY: Restrict the use of this power machine to persons who read,

understand and follow the warnings and instructions in this manual and on the machine.

NOTE: Not all safety labels shown may apply to your chipper shredder.

WARNING: DO NOT OPERATE

THIS MACHINE UNLESS THE

CHUTE DEFLECTOR HAS BEEN

PROPERLY INSTALLED AND IS

SECURED WITH THE HAND

KNOBS.

A DANGIII

ROTATING CUTTING BLADES.

KEEP HANDS AND FEET OUT

OF OPENING WHILE MACHINE

IS RUNNING.

■8k . ■PjllMk^N1 %llmm

ROTATING CUTTING BLADES.

KEEP HANDS AND FEET OUT

OF OPENINGS WHILE MACHINE

IS RUNNING.

SAFETY

GLASSES

SHOULD

BE WORN

DON'T DEPOSIT MATERIAL

LARGER THAN 1/2 INCH „

DIAMETER IN THE HOPPER S

THIS MAY CAUSE DAMAGE ^

TO SHREDDING MACHINE.

▲ DANGER

ASSEMBLE CHUTE DEFLECTOR

TO THIS UNIT

BEFORE OPERATING MACHINE.

SECTION 2: ASSEMBLING YOUR CHIPPER SHREDDER

IMPORTANT: This unit is shipped without gasoline or oil

in the engine. Be certain to service engine with gasoline

and oil as instructed in the separate engine manual

before operating your machine.

NOTE: Reference to right or left hand side of the

chipper shredder vacuum is observed from the

operating position.

Removing Unit From Carton

• Remove staples, break glue on top flaps, or cut

tape at carton end and peel along top flap to open

carton.

• Remove loose parts if included with unit (i.e.,

operator’s manual, etc.)

• Cut along corners, lay carton down flat, and remove

packing material.

• Roll or slide unit out of carton and check carton

thoroughly for loose parts.

Loose Parts In Carton (see Figured

• Hopper Assembly

• Discharge Chute

• Chipper Chute (463 thru 465)

• Bag (Not Shown)

Disconnecting Spark Plug Wire

Before setting up your chipper shredder, disconnect the

spark plug wire from the spark plug and ground against

the engine.

1 2 3 4 5 6 7 8 9 10 ... 13 14

Comments to this Manuals

No comments

Mtd 465 User Manual Page 5

Comments to this Manuals