MTD OEM-190-825 Operator's Manual download pdf (Page 20)

4. Attach the hose coupler to the water port on your

decks surface. See Figure 14.

Figure 14

5. Turn the water on.

6. While sitting in the operator’s position on the

tractor, start the engine and place the throttle lever

in the FAST (rabbit) position.

7. Move the tractor’s PTO (Blade Engage) into the ON

position.

8. Remain in the operator’s position with the cutting

deck engaged for a minimum of two minutes,

allowing the underside of the cutting deck to

thoroughly rinse.

9. Move the tractor’s PTO (Blade Engage) into the

OFF position.

10. Turn the ignition key to the STOP position to turn

the tractor’s engine off.

11. Turn the water off and detach the hose coupler

from the water port on your deck’s surface.

Repeat step 4- step 11 on the opposite side of the

cutting deck.

Lubrication

Engine

Lubricate the engine with motor oil as instructed in the

engine manual.

Pivot Points & Linkage

Lubricate all the pivot points on the drive system,

parking brake and lift linkage at least once a season

with light oil.

Deck Spindles

Grease fittings can be found on the front of each deck

spindle. After every 25 hours of tractor operation,

lubricate with 251H EP grease or an equivalent No. 2

multi-purpose lithium grease. Using a grease gun,

apply two strokes (minimum) or sufficient grease to

each spindle.

Rear Wheels

The rear wheels should be removed from the axles

once a season. Lubricate the axles and the rims well

with an all-purpose grease before re-installing them.

Front Wheels

Each of the front wheel axles is equipped with a grease

fitting. Lubricate with 251H EP grease or an equivalent

No. 2 multi-purpose lithium grease after every 25 hours

of tractor operation.

Transmission

The hydrostatic transmission is sealed at the factory.

Oil level cannot be checked nor can the oil be changed.

SECTION 8: SERVICE

Tires

WARNING: Never exceed the maximum

inflation pressure shown on the sidewall of the

tire.

The recommended operating tire pressure is

approximately 10 psi for the rear tires and 14 psi for the

front tires.

Refer to the tire sidewall for exact tire manufacturer’s

recommended or maximum psi. Do not overinflate.

Uneven tire pressure could cause the cutting deck to

mow unevenly.

Fuse

A fuse is installed in your tractor’s wiring harness to

protect the tractor’s electrical system from damage

caused by excessive amperage.

If the electrical system does not function, or your

tractor’s engine will not crank, first check to be certain

that the fuse has not blown.

It can be found under the hood mounted behind the top

of the dash panel on the support bar.

IMPORTANT:

Always use a fuse with the same

amperage capacity for replacement.

Water Port

Hose Coupler

For Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com

For Parts Call 606-678-9623 or 606-561-4983

www.mymowerparts.com

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

Comments to this Manuals

No comments

MTD OEM-190-825 Operator's Manual Page 20

Comments to this Manuals

Related products and manuals for Lawnmowers MTD OEM-190-825