MTD 214 KW Operations Instructions download pdf

’B’

’C’

cable/conduit

entry

200

Front view Side views

’A’ 135

214

155

ceiling mtd. wall mtd.

ceiling

THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE.

Dimensions

(millimetres)

Installation and Operating Instructions

Dimplex Air Curtains

Models : AC3N, AC45N, AC6N & AC3RN

08/18848/0 Issue 0

Fig. 1

Model(s) Watt

AC3N 3.0kw

AC45N 4.5kw

AC6N 6.0kw

AC3RN 3.0kw

Electrical

The installation of this appliance should be carried out by a

competent electrician and be in accordance with the current

IEE wiring regulations.

Wall mounting

Heaters may be mounted end to end for wide doorways.

Wall or Ceiling Mounting

Solid brick or concrete block walls must be drilled and plugged

(using a spirit level as a guide ensure bracket is level) with

rawlplug No. 8 size fibre inserts. The plug must be located in

the solid part of the wall, not just in the plaster layer.

For panelled internal walls or ceilings, it is best to locate the

studding, position the heater fixing bracket accordingly and

use No. 8 size wood screws. If it is not possible to locate the

studding, use type M4 Rawlplug inserts, making the 10mm

holes with a drill rather than a bradawl or a screwdriver.

Installation

This appliance may be either wall-mounted or fixed to a ceil-

ing - see Fig. 2 for various fixing positions and ‘Installation’ for

details on fixing.

Using the wall mounting bracket as a guide (see Fig. 3) mark

off the hole positions on the wall or ceiling - a minimum height

of 1.8metres is required from floor to bracket. Fix the bracket

in position by following steps as described under the heading

‘Wall or Ceiling Mounting’.

605

905

605

(Remote control)

Hole

centres

424

721

424

492

756

492

Bracket

length

Fig. 3

IMPORTANT SAFETY ADVICE

DO NOT COVER OR OBSTRUCT the air inlet or outlet

grille.

ENSURE THE APPLIANCE IS EARTHED.

Do not use this heater in areas where excessive dust

exists.

This heater must not be located immediately above

or below a fixed socket outlet or connection box.

Always disconnect supply before working on the

product.

This product should be mounted safely to solid wall

or ceiling surfaces only.

Ensure the supply cables are of adequate current car-

rying capacity and are protected by a suitable fuse.

If the appliance is mounted in a toilet or washroom,

the appliance should be mounted such that no part

of it can be touched by a person using a fixed bath or

shower.

If the appliance is mounted in a toilet or washroom

an isolating switch must be provided outside the

washroom adjacent to the entrance door.

wall

mounting

bracket

Locate the heater

on the mounting

bracket ensuring

that the pozi-head

screws are fully en-

gaged in the slots

of the bracket.

Fig. 2

Ceiling mounting

It is important that the serrated metal washer is located be-

tween the heater holding bracket and the wall mounting

bracket. Adjust heater to the required angle then firmly tighten

the fixing screws inside the endcap using a cross-head screw-

driver as shown in Fig. 4.

Fixing Positions

Fig. 4

serrated washer

wall

mounting

bracket

access hole for

screwdriver

holding bracket

fixing screw

Detail view of Wall fixing bracket arrangement

see Fig. 4

1 2 3 4

Summary of Contents

Page 1 - Dimplex Air Curtains

’B’’C’cable/conduitentry4520050Front view Side views’A’ 135214155ceiling mtd. wall mtd.ceiling THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINE

Page 2 - CUT-OUT CUT-OUT

MElementCUT-OUTCUT-OUTElementIsolatorSwitchHeatETerminalBlockENLESwitchesElementCUT-OUTElementCUT-OUTMLOUT INNIsolatorSwitchSwitchesLNEEHeatBlockTermi

Page 3 - Operation (AC3RN model)

AUTOMANgreenneon lightON buttonOFF buttonwallmountedholsterresetbutton (AC3RN only)Operation (AC3N, AC45N & AC6N models)Fig. 12Operation (AC3RN m

Page 4

Glen Dimplex UK LimitedMillbrook HouseGrange DriveHedge EndSouthamptonHampshire. SO30 2DFUK customer help line (8.00AM – 6.00PM Mon-Fri; 8.30AM-1.00

Comments to this Manuals

No comments

MTD 214 KW Operations Instructions

Browse online or download Operations Instructions for Lawnmowers MTD 214 KW. MTD 214 KW Operating instructions User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lawnmowers MTD 214 KW