Mtd 111-638A User Manual download pdf (Page 11)

TO REMOVE GRASS

CATCHER

1. To remove the grass catcher, lift the rear of

grass catcher, push forward and unhook lock

ing lever.

2. Lift off grass catcher. See figure 20.

OPERATION

DO NOT OPERATE THIS

MOWER WITH THE CHUTE

DOOR OPEN. UNLESS THE

COMPLETE GRASSCATCHER

IS PROPERLY MOUNTED ON

THE MOWER.

NOTE

For shipping purposes your mower

is set with the wheeis in a low cut

ting height position. For best

results, raise the cutting position

until it is determined which height

is best for your lawn. See adjust

ment section.

BEFORE STARTING

1. Check to see that the handle is in the

operating detent in the brackets on the deck,

and the upstop projections restrict the handle

from moving up and forward. If necessary,

remove the left side from the mounting pin on

the deck bracket. Push inward to decrease the

spacing between the two sides of the handle

until it is slightiy less than the spacing of the

deck brackets. Reinstaii over the mounting

pin and secure the hairpin cotter in the inner

hoies.

2. Fili sump with oii, using a high quaiity

detergent oil classified “For Service SC, SD,

SE or MS.” Use SAE 30, SAE 10W-30 or SAE

10W-40 viscosity grade oil. Nothing should be

added to the recommended oil.

Place engine level. Remove the dipstick. See

figure 22. Fill to full mark on dipstick. Pour slowly.

Capacity 1V4 pints.

FIGURE 21.

Keep hands and feet away from the chute area on

cutting deck. See figure 21.

FIGURE 22.

3. Fill fuel tank, using clean, fresh leaded regular

grade automotive gasoline. Fill tank com

pletely.

DO NOT MIX OIL WITH GASOLINE.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18 19

Comments to this Manuals

No comments

Mtd 111-638A User Manual Page 11

Comments to this Manuals

Related products and manuals for Gardening equipment Mtd 111-638A