Mtd 111-020-300 User Manual Page 1

.50ASSEMBLY » OPERATION » MAINTENANCE » PARTS18" ROTARY MOWERSImportant:Read Safety Rules and Instructions CarefullyThank you for purchasing an A

Screw Assemble One of These Low Points Towards Narrow Edge of ElementAssemble Element So Lip Extends Over Edge of Air Cleaner BodyLip Will Form Prote

NOTEThe use of any accessory on this Rotary Mower other than those manufactured by the mower manufacturer is not recommended.GRASS CATC

111-020A 111-021A 111-020-300 55 111-021IF YOU WRITE TO US ABOUT THIS ARTICLE OR IF YOU ORDER REPLACEMENT PARTS ALWAYS MENTION THIS MODEL & SERIA

111-020A 111-021A 111-020-300 111-021-300PARTS LIST FOR MODELS 111-020A AND 111-021AREF.NO.PARTNO.COLORCODEDESCRIPTIONNEWPART111190—456 Protective Shi

PARTS INFORMATIONPOWER EQUIPMENT PARTS AND SERVICEParts and service for all MTD manufactured power equipment are available through the aut

INDEXSafe Operation Practices...3Assembiy... ...

IWARNjNG {following safety instructions. Failure to compiy withTo reduce the potentiai for any injury, compiy with the the instructions may resuit in

AS-í^^ASSEMBLY INSTRUCTIONSBJk IVVGFIGURE 1.FIGURE 2.Shoulder Bolt (E) Belleville Washer (F) Wheel (I)FIGURE 3.FourCuttingHeightsNOTEThis unit is s

LowerHandle (K)------► /7. Place the upper slotted hole in lower handle (K) over studs located in front of each rear wheel. Secure with hairpin cott

Cable Tie (D)11. Secure throttle control wire to handle with two cable ties (D) provided in hardware pack.------See figure 7.12. Slip hand g

1. FILL SUMP WITH OIL using a high quality detergent oil classified “For Service SC, SD, SE or MS.” Nothing should be added to t

CARBURETOR ADJUSTMENTS (See Figure 11)Minor carburetor adjustment may be required to compensate for differences in fuel, temperature, altit

3. If the blade or blade adapter needs replacing, remove the two small bolts, lock washers and nuts which hold the blade to the adapter