Mtd 110-518R000 User Manual

$1.00OWNEirS GUIDEASSEMBLY • OPERATION • MAINTENANCE • PARTSOi "^ * Model NumbersROTARY 110-516R000MOWERS 110-518R000QTi C/mtE«.- [MMDj on 0/m

RearDeflectorAHACHING BAG TO MOWERLift the rear deflector on the mower. Place the hooks on the grass catcher over the pins on the back of the

OPERATIONTO REDUCE THE RISK OF INJURY. DO NOT OPERATE MOWER UNLESS REAR TRAILING SHIELD AND THIS GUARD OR ENTIRE GRASS CATCHER IS IN ITS PROPER PLACE.

A WARNING: The blade continues to rotate for a few seconds after the engine is shut off.2. Disconnect the spark plug wire and ground

LUBRICATIONAWARNING: Always stop engine and disconnect spark plug wire before cleaning, lubricating or doing any kind of work on lawn

ENGINERefer to the separate engine manual for engine maintenance instructions.Maintain engine oil as instructed in the seaarate engine m

TROUBLE SHOOTING GUIDETroublePossible Cause(s) Corrective ActionEngine fails to start 1. Blade control handle disengaged.2. Spark plug wire disconne

Models 516R and 518Rr\Y{-}(aG( CAfJ3"This instruction manuai covers various models and all specifications shown do not necessarily apply to

PARTS LIST FOR MODELS 516R AND 518R ROTARY MOWERSREF.iNO.PARTNO.CODE DESCRIPTIONREF.NO.PARTNO.CODE DESCRIPTION1747-0748N Control Handle Ass’y. (Std.)5

*For faster service obtain standard nuts, boits and washers ocaily. If these items cannot be obtained locally, order by part numi )er and size as show

"N

INDEXSlope Gauge... 3Contents of Hardware Pack...

PARTS INFORMATIONPOWER EQUIPMENT PARTS AND SERVICEParts and service are available through the authorized service firms listed below. All orders should

--UUIMK ^nisLine-A-USE THIS SHEET AS A GUIDE TO DETERMINE SLOPES WHERE YOU MAY NOT OPERATE SAFELY.CO...SI

CONTENTS OF HARDWARE PACKRemove this sheet from your owner’s manual and lay the hardware on the illustration for identification purposes. After assemb

IMPORTANTRULES FOR SAFE OPERATIONATHIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSON

ASSEMBLY INSTRUCTIONSIMPORTANT: This unit is shipped WITHOUT GASOLINE or OIL. After assembly, service engine with gasoline and oil as

AHACHING THE THROHLE CONTROL (Hardware C)The throttle control is attached to the engine. Attach the throttle control to the left side of upp

ATTACHING THE REAR WHEELS (Hardware E)-Assemble the rear wheels as follows. See figure 7.1. Move the wheel height adjusters so the deck is in the low

2. Slide the ends of the front frame assembly into the —ends of the rear frame as shown in figure 10A.3. Secure front of bag to front frame b