Mtd 110-112A User Manual download pdf (Page 4)

Lower

Handle

Inner

Hole

Outer

Hole

N ■.

Weld Pin

Handle

Bracket

FIGURE 1.

ASSEMBLY

INSTRUCTIONS

1. Extend throttle control which is attached to

the engine at the rear of the mower and place

on the floor. Be careful not to bend or kink

control wire.

2. Fasten lower handle in position over weld

pins in handle mount brackets on deck.

—Secure with hairpin cotters in inner hole on

weld pin. See figure 1.

NOTE

There are two (2) holes in the handle

mount brackets. Place the lower

handle against the brackets and

secure with hairpin cotter in the in

ner hole. Inner hole is for operation.

Outer hole is for storage.

NOTE

It may be necessary to pull open the

ends of the lower handle. This will

insure a tight fit when assembled in

to handle mount brackets.

3. Assemble upper handle to lower handle.

— Secure with two carriage bolts and hex lock

nuts as shown in figure 2.

NOTE

There are two height positions for

the handle. See adjustment section.

FIGURE 2.

Place the throttle control in position on right

side of upper handle. Secure with hex bolt and

lock nut. See figure 3.

NOTE

■Reference to right and left hand

sides of the unit is observed from

the operating position.

FIGURE 3.

1 2 3 4 5 6 7 8 9 ... 13 14

Comments to this Manuals

No comments