MTD OHV Series Operations Instructions download pdf (Page 9)

English Operating manual for engine

If oil with an individual viscosity is

used, a viscosity should be selected

from the table for the average

tempe-rature in the application area.

`~ìíáçå>

fÑ=~å=áåÑÉêáçê=çáä=çê=~å=çáä=Ñçê=OJëíêçâÉ=

ÉåÖáåÉë=áë=ìëÉÇI=íÜÉ=ëÉêîáÅÉ=äáÑÉ=çÑ=

íÜÉ=ÉåÖáåÉ=ã~ó=ÄÉ=Ç~ã~ÖÉÇK

Checking the oil level

`~ìíáçå>

tÜÉå=ÅÜÉÅâáåÖ=íÜÉ=çáäI=ÉåëìêÉ=íÜ~í=

íÜÉ=ìåáí=áë=çå=~=äÉîÉä=ëìêÑ~ÅÉ=~åÇ=íÜ~í=

íÜÉ=ÉåÖáåÉ=áë=ëïáíÅÜÉÇ=çÑÑK

Fig. 2

 Unscrew the oil filler cap (1) and

wipe the dip stick.

 Insert the dip stick into the filler

neck.

Screw in one quarter turn.

 Unscrew dipstick.

 Pull out the dipstick and check the

oil level.

If the level is too low, slowly pour

in a little oil up to the upper “max”

mark on the dip stick.

 Before starting the engine, firmly

screw in the dip stick.

`~ìíáçå>

aç=åçí=éçìê=áå=íçç=ãìÅÜ=çáäK=

qçç ãìÅÜ=çáä=ã~ó=êÉëìäí=áå=ÉåÖáåÉ=

Ç~ã~ÖÉI=ëãçâÉ=ÖÉåÉê~íáçåI=ëí~êíáåÖ=

éêçÄäÉãëI=ëççíÉÇ=ëé~êâ=éäìÖ=çê=

çáäÉÇJìé=~áê=ÑáäíÉêK

Recommended fuels

a~åÖÉê>

Ó råÇÉê=ÅÉêí~áå=ÅçåÇáíáçåë=éÉíêçä=áë=

ÉñíêÉãÉäó=Ñä~ãã~ÄäÉ=~åÇ=

ÉñéäçëáîÉK

Ó oÉÑìÉä=çåäó=áå=ïÉää=îÉåíáä~íÉÇ=

ëìêêçìåÇáåÖë=~åÇ=ïáíÜ=íÜÉ=ÉåÖáåÉ=

ëïáíÅÜÉÇ=çÑÑK=aç=åçí=ëãçâÉ=åÉ~ê=

íÜÉ=ÑìÉä=í~åâ=çê=áå=íÜÉ=ÑìÉä=ëíçê~ÖÉ=

äçÅ~íáçå=~åÇ=ÉñíáåÖìáëÜ=~ää=áÖåáíáçå=

ëçìêÅÉëK

Ó aç=åçí=çîÉêÑáää=íÜÉ=éÉíêçä=í~åâ=

EíÜÉêÉ=ãìëí=ÄÉ=åç=ÑìÉä=áå=íÜÉ=ÑáääÉê=

åÉÅâFK=^ÑíÉê=êÉÑìÉääáåÖI=ÉåëìêÉ=íÜ~í=

íÜÉ=ÑìÉä=Å~é=áë=ÅäçëÉÇ=~åÇ=

ëÉÅìêÉÇK

Ó tÜÉå=êÉÑìÉääáåÖI=Çç=åçí=ëéáää=~åó=

ÑìÉäK=péáääÉÇ=ÑìÉä=çê=éÉíêçä=î~éçìêë=

ã~ó=áÖåáíÉK=fÑ=ÑìÉä=ï~ë=ëéáääÉÇI=

ÉåëìêÉ=íÜ~í=íÜÉ=~êÉ~=áë=ÇêáÉÇ=

ÄÉÑçêÉ=êÉëí~êíáåÖ=íÜÉ=ÉåÖáåÉK

Ó ^îçáÇ=êÉéÉ~íÉÇ=çê=éêçäçåÖÉÇ=ëâáå=

Åçåí~Åí=~åÇ=áåÜ~ä~íáçå=çÑ=íÜÉ=

î~éçìêëK

oáëâ=çÑ=ÉåÖáåÉ=Ç~ã~ÖÉ>

Ó aç=åçí=ãáñ=ÑìÉä=~åÇ=çáäK

Ó rëÉ=ÅäÉ~åI=ÑêÉëÜ=~åÇ=ìåäÉ~ÇÉÇ=

ÑìÉä=çåäóK

Ó rëÉ=ÑìÉä=ïáíÜ=~å=çÅí~åÉ=åìãÄÉê=çÑ=

UT=çê=ÜáÖÜÉê=çåäóK

Ó aç=åçí=ìëÉ=ÑìÉä=çÑ=ëéÉÅáÑáÅ~íáçå=

b=URLbNR>

Ó píçêÉ=ÑìÉä=áå=èì~åíáíáÉë=ïÜáÅÜ=Å~å=

ÄÉ=ìëÉÇ=ïáíÜ=áå=PM=Ç~óëK

Ó båëìêÉ=íÜ~í=åç=ÇáêíI=Çìëí=çê=ï~íÉê=

ÖÉíë=áåíç=íÜÉ=í~åâK

Checking the petrol level

`~ìíáçå>

_ÉÑçêÉ=êÉÑìÉääáåÖI=äÉ~îÉ=íÜÉ=ÉåÖáåÉ=íç=

Åççä=Ççïå=Ñçê=~í=äÉ~ëí=íïç=ãáåìíÉëK

 Before removing the fuel cap and

refuelling, clean the area around

the filler neck.

 Fill the tank until approx. 2 cm

below the rim of the filler neck to

allow the fuel to expand.

Starting the engine

a~åÖÉê>

hÉÉé=Ü~åÇë=~åÇ=ÑÉÉí=~ï~ó=Ñêçã=

ãçîáåÖ=é~êíëK=aç=åçí=ìëÉ=~åó=

éêÉëëìêáëÉÇ=ëí~êíáåÖ=~áÇëK=

qÜÉ î~éçìêë=~êÉ=Ñä~ãã~ÄäÉK

a~åÖÉê>=

cçääçï=~ää=çéÉê~íáåÖ=áåëíêìÅíáçåë=áå=

íÜÉ=çéÉê~íáåÖ=ã~åì~ä=Ñçê=íÜÉ=ìåáí=çå=

ïÜáÅÜ=íÜáë=ÉåÖáåÉ=áë=ãçìåíÉÇK

Note:

Some models have

– no choke and no primer:

The engine is automatically set to

the particular starting process.

– no throttle:

The speed is automatically set.

The engine always runs at

optimum speed.

Fig. 3

Preparing to start the engine

If the engine is cold:

 Set throttle (1; if fitted) to

position .

 Actuate the choke, i.e. pull out the

choke lever (10, Fig. 1; if fitted).

 Press the primer (7, Fig. 1;

if fitted):

– at temperatures above 10 °C:

Press 1–3x

– at temperatures below 10 °C:

Press 3–5x

Note:

– When pressing the primer, cover

the vent hole on the primer button

with your finger.

– If the engine does not start,

actuate the primer again.

If the engine is warm:

 Set throttle (1; if fitted) to

MAX/ .

Important

Even if the engine is warm, it may be

necessary

– to actuate the choke (if fitted)

– to actuate the primer (if fitted) 1x.

Starting with the hand starter

 Open fuel tap (11, Fig. 1; if fitted).

 Set On/Off switch on the engine

(9, Fig. 1; if available) to position

“On/I”.

 Stand behind the unit, depress

the safety lever (2; if fitted) and

hold down against the handle.

 Pull gently on the starter handle (3)

until it begins to resist. Then pull

quickly and forcefully to overcome

the compression and prevent

a backlash. If required, repeat.

`~ìíáçå>

aç=åçí=äÉí=íÜÉ=ëí~êíÉê=Ü~åÇäÉ=ëéêáåÖ=

Ä~Åâ=~Ö~áåëí=íÜÉ=ÉåÖáåÉK=päçïäó=

ÖìáÇÉ=áí=Ä~Åâ=íç=éêÉîÉåí=Ç~ã~ÖáåÖ=

íÜÉ=ëí~êíÉêK

1 2 3 4 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments

MTD OHV Series Operations Instructions Page 9

Comments to this Manuals

Related products and manuals for Engine MTD OHV Series