Mtd H660G User Manual download pdf (Page 10)

Figure 9

• Repeat Auger Control Test to verify proper

adjustment has been achieved.

Chute Clean-Out Tool

The chute clean-out tool is conveniently fastened to the

rear of the auger housing with a mounting clip (Refer to

Figure 7). If the discharge chute becomes clogged

during operation, proceed as follows to safely clean the

chute and chute opening:

1. Release both the Auger Control Lever and the

Traction/Auger Control Lock Lever.

2. Stop the engine by removing the ignition key.

3. Remove the clean-out tool from the clip which

secures it to the rear of the auger housing.

4. Use the shovel-shaped end of the clean-out tool to

remove any snow and ice in the discharge chute.

WARNING: Never use your hand to clear a

clogged discharge chute. Shut off engine and

remain behind handles until all moving parts

have stopped before unclogging.

5. Refasten the clean-out tool to the mounting clip on

the rear of the auger housing, re-start the engine.

6. While standing in the operator’s position (behind

the snow thrower), engage the auger clutch lever

for a few seconds to clear any remaining snow or

ice from the discharge chute before continuing to

clear snow.

Tire Chains (Optional Equipment)

Tire chains may be used whenever extra traction is

needed. Contact Customer Support as instructed on

page 2 for information regarding price and availability.

Drift Cutters (Optional Equipment)

Drift cutters should be used when operating the snow

thrower in heavy drift conditions.

On models so equipped, drift cutters are assembled to

the auger housing inverted. Remove the carriage bolts

by unthreading the hex nuts which secure them, and

reinstall the drift cutters in their proper position before

operating the snow thrower. See Figure 10.

Figure 10

If your unit is not equipped with drift cutters, contact

Customer Support as instructed on page 2 for

information regarding price and availability.

Snow Thrower Model Drift Cutter Kit

All models OEM-390-679

Operating Tips

NOTE: Allow the engine to warm up for a few minutes

as the engine will not develop full power until it reaches

operating temperature.

WARNING: The muffler, engine and their

surrounding areas become hot and can cause

a burn. Do not touch.

• Discharge snow downwind whenever possible.

Slightly overlap each previous path.

• Set the skid shoes 1/4" below the scraper bar for

normal usage. The skid shoes may be adjusted

upward for hard-packed snow. Adjust downward

when using on gravel or crushed rock.

• Avoid possible starter freeze-up. Clean the snow

thrower thoroughly after each use.

“Z”

Jam Nut

Fitting

Auger Control

Make Sure Cable

Is Straight

Lever

Handle

Panel

Carriage Screws/

Hex Nuts

Drift

Cutter

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Comments to this Manuals

No comments

Mtd H660G User Manual Page 10

Comments to this Manuals

Related products and manuals for Cars Mtd H660G