Mtd 248-650-000 User Manual

$1.00OWNHrS GUIDEOUTDOOR POWER EQUIPMENT for all seasonsIMPORTANT:Read Safety Rules and Instructions Carefully5 H.R SHREDDERModels Numbers248-650-0

When reassembling the blade, tighten to betweer 375 and 450 inch pounds, or lacking torque wrench, tighten securely.OFF-SEASON STORAGEIf the shredder

TROUBLE SHOOTING CHART^ SYMPTON POSSIBLE CAUSE(S)SOLUTIONEngine fails to start1. Check fuel tank for gas.1. Fill tank if empty.2. Spark plug lead wire

Model 65012

Model 650PARTS LIST FOR MODEL 650 SHREDDERef.No.PartNo.ColorCodeDescriptionNewPartRef.No.PartNo.ColorCodeDescriptionNewPart1 11476 Door Chip It31 714-

REPLACEMENT PARTS • P.O. BOX 36900 • CLEVELAND, OHIO 44136

INDEXRules for Safe Operation...3Assembly... .4Operation...

A>:WARNING♦♦To reduce the potential for any injury, comply with the following safety instructions. Failure to comply with the instructions may res

NOTEThis unit is shipped WITHOUT GASOLINE or OIL. After assembly, see separate engine manual for proper fuel and engine oil recommendations.ASSEM

INSTALLATION OF HOPPER AND UPPER GUIIDE EXTENSION1.2.Lower Leaf Ramp SectionThe lower leaf ramp section on the shredder is placed in an u

ATTACHING THE CATCHER BAGYour unit is equipped with a nylon bag which attaches to the discharge opening. If desired, place the end of the bag over the

AirScreenTO STOP ENGINE1. Move throttle control lever to OFF position.2. Disconnect spark plug wire from spark plug and ground against the engin

Lower the leaf ramp by holding the handle and puHing up on the release bar. See figure 11. Leaves and small twigs can be raked into the shredder with

MAINTENANCEAiWARNING {Disconnect spark plug wire and ground it against the engine before performing any repairs or maintenance.ENGINERefer to t