Mtd 247-650-000 User Manual

$1.005 H.R SHREDDERModel Numbers247-650-00024650BIMPORTANT: Read Safety Rules and Instructions CarefullyThank you for purchasing an American-built pro

When reassembling the blade, tighten to between 375 and 450 inch pounds, or lacking torque wrench, t ghten securely.FLAILS AND FINGERSThe flails and

TROUBLE SHOOTING CHARTSYMPTON POSSIBLE CAUSE(S)SOLUTIONEngine fails to start 1.Check fuel tank for gas. 1. Fill tank if empty.2.Spark plug lead wire d

Model 65012

Model 650PARTS LIST FOR MODEL 650 SHREDDERRef.No.PartNo.ColorCodeDescriptionNewPartRef.No.PartNo.ColorCodeDescriptionNewPart111476 Door Chip It31 714-

MTD PRODUCTS INC ... VaRD-MaN COMPANYP.O. BOX 36900 • CLEVELAND OHIO 44136

INDEXRules for Safe Operation...3Assembly...4O

WARNING♦♦To reduce the potential for any injury, comply with the following safety instructions. Failure to comply with the instructions may result in

NOTEThis unit is shipped WITHOUT GASOLINE or OIL. After assembly, see separate engine manual for proper fuel and engine oil recommendations.ASSEM

Hopper-^Self-Tapping Screws (C)INSTALLATION OF HOPPER AND UPPER GUIIDE EXTENSION1.2.Lower Leaf Ramp SectionThe lower leaf ramp section on the s

ATTACHING THE CATCHER BAGYour unit is equipped with a nylon bag which attaches to the discharge opening. If desired, place the end of the bag over the

TO STOP ENGINE1. Move throttle control lever to STOP position.2. Disconnect spark plug wire from spark plug and ground against the engine to

Lower the leaf ramp by holding the handle and p jlling up on the release bar. See figure 11. Leaves and small twigs can be raked into the shredder wit

MAINTENANCEAc WARNING \Disconnect spark plug wire and ground it against the engine before performing any repairs or maintenance.ENGINERefer to